Journal - Week #10

Monday, April 25, 2011 - Easter Monday - No school
Tuesday, April 26, 2011 - Worked on my bubble diagram for designing my house. Also looked over a note for a more detailed look at it. Envisoneer is the next stage, this is going to be fun.
Wednesday, April 27, 2011 - Floor plan is becoming a giant pain.
Thursday, April 28, 2011 - Tried to figure out how to do the floor plan on AutoCAD. Pain in the butt because the rules keep on getting changed.
Friday, April 29, 2011 - Was not at school, I was helping out at track & field.

Journal - Week #9

Monday, April 18, 2011 - We listened to the people in the grade 12 course give a presentation on Threads, Fasteners, and Tolerancing.
Tuesday, April 19, 2011 - The teacher was sick so we did four quizzes on the internet about Threads, Fasteners, and Tolerancing. Also worked on our floor plans.
Wednesday, April 20, 2011 - Worked on house floor plan.
Thursday, April 21, 2011 - Not here, doctor's appointment
Friday, April 22, 2011 - Good Friday, no school.

Chapter 12 Quiz 6

1 Correct		The easiest way to create fasteners on a bolt circle in AutoCAD LT® is to
			A) create each fastener individually.
			B) create one fastener and copy it to the other locations.
			C) create one fastener and use a rectangular array to place the others.
			D) create one fastener and use a polar array to place the others.
2 Correct		When you create a rectangular array, the Array dialog box allows you to specify all of the following except
			A) the amount of space between rows and columns.
			B) the size of each object in the array.
			C) the number of rows.
			D) the number of columns.
3 Correct		When you create a polar array, you can place the center point of the array by all of the following means except
			A) entering relative coordinates.
			B) entering X and Y coordinates.
			C) picking an arbitrary point anywhere in the drawing area.
			D) using object snaps.
4 Correct		The total number of objects in an array consisting of six rows and four columns is
			A) 18.
			B) 24.
			C) 36.
			D) 48.
5 Correct		The TOLERANCE command is used to apply
			A) basic tolerances.
			B) deviation tolerances.
			C) limits tolerances.
			D) feature control frames and datum references.
6 Correct		When you pick the Sym box in the Geometric Tolerance dialog box, the
			A) diameter symbol (Ø) appears.
			B) Symbol dialog box appears.
			C) Datum dialog box appears.
			D) radius symbol (R) appears.
7 Correct		The TOLERANCE command allows you to create multiple tolerances, up to a maximum of
			A) 2.
			B) 3.
			C) 4.
			D) 5.
8 Correct		In the Material Condition dialog box, the blank box at the right end allows you to
			A) specify a nonstandard material condition.
			B) open a new dialog box with additional material condition options.
			C) remove an existing material condition from the feature control frame.
			D) create a custom material condition symbol.
9 Correct		The Height box in the Geometric Tolerance dialog box
			A) specifies the height of each tolerance in the feature control frame.
			B) specifies the height of the entire feature control frame.
			C) creates a primary datum references.
			D) creates a projected tolerance zone value.
10 Correct		The Projected Tolerance Zone box in the Geometric Tolerance dialog box
			A) inserts a projected tolerance zone symbol.
			B) opens a dialog box allowing you to select a projected tolerance zone.
			C) creates a projected tolerance zone value.
			D) inserts a datum identifier.